/*
*   This factory is just to test LilyGo T-Beam series hardware
*   Created by Lewis he
* */

// #define T_BEAM_V07
#define T_BEAM_V10      //same v1.1 version


#include <SPI.h>

#if defined(T_BEAM_V07)
#define GPS_RX_PIN 12
#define GPS_TX_PIN 15
#define BUTTON_PIN 39
#define BUTTON_PIN_MASK GPIO_SEL_39
#elif defined(T_BEAM_V10)
#define GPS_RX_PIN 34
#define GPS_TX_PIN 12
#define BUTTON_PIN 38
#define BUTTON_PIN_MASK GPIO_SEL_38
#endif

#define I2C_SDA                     21
#define I2C_SCL                     22
#define PMU_IRQ                     35

#define RADIO_SCLK_PIN               5
#define RADIO_MISO_PIN              19
#define RADIO_MOSI_PIN              27
#define RADIO_CS_PIN                18
#define RADIO_DI0_PIN               26
#define RADIO_RST_PIN               23
#define RADIO_DIO1_PIN              33
#define RADIO_BUSY_PIN              32

#define GPS_BAND_RATE      9600

#ifdef T_BEAM_V10
#include <axp20x.h>
AXP20X_Class PMU;

bool initPMU()
{
    Wire.begin(I2C_SDA, I2C_SCL);

    if (PMU.begin(Wire, AXP192_SLAVE_ADDRESS) == AXP_FAIL) {
        return false;
    }
    /*
     * The charging indicator can be turned on or off
     * * * */
    // PMU.setChgLEDMode(LED_BLINK_4HZ);

    /*
    * The default ESP32 power supply has been turned on,
    * no need to set, please do not set it, if it is turned off,
    * it will not be able to program
    *
    *   PMU.setDCDC1Voltage(3300);
    *   PMU.setPowerOutPut(AXP192_DCDC1, AXP202_ON);
    *
    * * * */

    /*
     *   Turn off unused power sources to save power
     * **/
    PMU.setPowerOutPut(AXP192_DCDC2, AXP202_OFF);
    PMU.setPowerOutPut(AXP192_LDO2, AXP202_OFF);
    PMU.setPowerOutPut(AXP192_LDO3, AXP202_OFF);
    PMU.setPowerOutPut(AXP192_EXTEN, AXP202_OFF);

    /*
     * Set the power of LoRa and GPS module to 3.3V
     **/
    PMU.setLDO2Voltage(3300);   //LoRa VDD
    PMU.setLDO3Voltage(3300);   //GPS  VDD

    PMU.setPowerOutPut(AXP192_LDO2, AXP202_ON);
    PMU.setPowerOutPut(AXP192_LDO3, AXP202_ON);

    return true;
}

#else
#define initPMU()
#endif

void initBoard()
{
    Serial.begin(115200);
    Serial.println("initBoard");
    Serial1.begin(GPS_BAND_RATE, SERIAL_8N1, GPS_RX_PIN, GPS_TX_PIN);
    SPI.begin(RADIO_SCLK_PIN, RADIO_MISO_PIN, RADIO_MOSI_PIN, RADIO_CS_PIN);
    initPMU();
}